Please submit manuscripts in either of the following two submission systems

    ScholarOne Manuscripts

  • ScholarOne
  • 勤云稿件系统

  • 登录

Search by Issue

  • 2024 Vol.31
  • 2023 Vol.30
  • 2022 Vol.29
  • 2021 Vol.28
  • 2020 Vol.27
  • 2019 Vol.26
  • 2018 Vol.25
  • 2017 Vol.24
  • 2016 vol.23
  • 2015 vol.22
  • 2014 vol.21
  • 2013 vol.20
  • 2012 vol.19
  • 2011 vol.18
  • 2010 vol.17
  • 2009 vol.16
  • No.1
  • No.2

Supervised by Ministry of Industry and Information Technology of The People's Republic of China Sponsored by Harbin Institute of Technology Editor-in-chief Yu Zhou ISSNISSN 1005-9113 CNCN 23-1378/T

期刊网站二维码
微信公众号二维码
Related citation:
【Print】   【HTML】   【PDF download】   View/Add Comment  Download reader   Close
Back Issue    Advanced Search
This paper has been: browsed 3940times   downloaded 3357times  
Shared by: Wechat More
Preliminary Investigation of Copper Joints Soldered with Sn58Bi
Author NameAffiliationPostcode
Amares Singh* 1. Cent er for Advanced Materials Research and Manufacturing Proce sses, SEGi University, Petaling Jaya 47810, Selangor, Malaysia
2. Lee Kong Chian Faculty of Engineering and Science, University Tunku Abdul Rahman, Kajang 43000, Selangor, Malaysia 
47810
Teow Sinn Khai Center for Advanced Materials Research and Manufacturing Processes,SEGi University,Petaling Jaya ,Selangor,Malaysia 
Rajkumar Durairaj Lee Kong Chian Faculty of Engineering and Science,University Tunku Abdul Rahman,Kajang ,Selangor,Malaysia 
Amer Ahmed Qassem Saleh Center for Advanced Materials Research and Manufacturing Processes,SEGi University,Petaling Jaya ,Selangor,Malaysia 
Abstract:
In recent years, intensive studies have been carried out to find an alternative for Tin (Sn)-Lead (Pb) solder alloys with increasing demand over lower temperature solder alloys in current electronic packaging industry. High temperature operational solder alloys seem to produce drawback to other components on the printed circuit board (PCB). Low melting temperature Sn58Bi substrate as a potential replacement was investigated in this paper based on the melting properties, wettability, and shear strength. The Sn58Bi was soldered at a temperature below 200 °C on the Cu substrate and the shear strength and contact angle were calculated. A peak temperature (melting temperature, TM) of 144.83 °C was identified. Single lap joint method was performed at a strain rate of 0.1 mm/min and an average shear strength of 23.4 MPa was found from three samples. The contact angle (wettability) was calculated to study the solder joint behaviour at reflow temperature of 170 °C. The contact angle of the Sn58Bi was found to be 32.4 ° and considered to be desired value since the angle is less than 50 °. These low temperature soldering provides a preliminary result to allow further application on the real PCB.
Key words:  SnBi solder  low temperature  shear strength  contact angle
DOI:
Clc Number:TG49
Fund:

LINKS