期刊检索

  • 2024年第32卷
  • 2023年第31卷
  • 2022年第30卷
  • 2021年第29卷
  • 2020年第28卷
  • 2019年第27卷
  • 2018年第26卷
  • 2017年第25卷
  • 2016年第24卷
  • 2015年第23卷
  • 2014年第22卷
  • 2013年第21卷
  • 2012年第20卷
  • 2011年第19卷
  • 2010年第18卷
  • 第1期
  • 第2期

主管单位 中华人民共和国
工业和信息化部
主办单位 中国材料研究学会
哈尔滨工业大学
主编 苑世剑 国际刊号ISSN 1005-0299 国内刊号CN 23-1345/TB

期刊网站二维码
微信公众号二维码
引用本文:杨德明,田博涵,高阳.低压等离子喷涂316L等轴晶涂层及其性能研究[J].材料科学与工艺,2011,19(4):24-27.DOI:10.11951/j.issn.1005-0299.20110406.
YANG De-ming,TIAN Bo-han,GAO Yang.Microstructure and mechanical properties of the equiaxed 316L coating deposited by low pressure plasma spraying[J].Materials Science and Technology,2011,19(4):24-27.DOI:10.11951/j.issn.1005-0299.20110406.
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 1533次   下载 1284 本文二维码信息
码上扫一扫!
分享到: 微信 更多
低压等离子喷涂316L等轴晶涂层及其性能研究
杨德明, 田博涵, 高阳
大连海事大学热喷涂中心
摘要:
为研究低压等离子喷涂等轴晶涂层组织性能和形成机理,采用大气等离子喷涂(APS)和低压等离子喷涂(LPPS),分别制备了316L不锈钢涂层.利用金相显微镜,X射线衍射和显微硬度等方法,分析了2种涂层的金相组织、相结构、显微硬度和耐蚀性.结果表明:一定条件下制备的低压等离子喷涂SUS316L不锈钢涂层明显不同于传统大气等离子喷涂组织,为类似于锻造或铸造结构的等轴晶组织,低压等离子喷涂涂层等轴晶粒致密、细小,涂层中无氧化物相存在,耐蚀性优于大气等离子喷涂涂层.大气等离子喷涂层为片状堆积结构涂层,硬度高于低压等离子喷涂等轴晶涂层.
关键词:  低压等离子喷涂  涂层  316L  等轴晶
DOI:10.11951/j.issn.1005-0299.20110406
分类号:TG174.4
基金项目:国家自然科学基金资助项目(51172033)
Microstructure and mechanical properties of the equiaxed 316L coating deposited by low pressure plasma spraying
YANG De-ming, TIAN Bo-han, GAO Yang
Dalian Maritime University,Center of Thermal Spray,Dalian 116026,China
Abstract:
To investigate the microstructure and properties of low pressure plasma sprayed equiaxed coatings, SUS 316L stainless coatings were prepared by air plasma spray(APS)and low pressure plasma spray(LPPS) processes.The microstructure,phase composition,microhardness and corrosion resistance of the coatings were investigated using optical micrograph(OM),X-ray diffraction(XRD)and so on.The results show that the microstructure of LPPS 316L coatings reveals the fine equiaxed microstructure similar to bulk stainless steel with nearly oxides-free,which is significantly different from that of APS coating with lamellar structure.Compared with APS coating,the coating prepared by LPPS also shows relatively high corrosion resistance.The lamellar structure of APS coating resulted in anisotropic character and high cooling rate during splat cooling leads to higher microhardness than that of LPPS equuiaxed coating.
Key words:  low pressure plasma spray  coatings  316L  equiaxed microstructure

友情链接LINKS