| 引用本文: | 袁书强,沈正祥,周春华,刘峰涛,王芳,杨辉,陈炯.不同热处理条件下30CrMnSiNi2A钢的组织性能研究[J].材料科学与工艺,2015,23(2):125-128.DOI:10.11951/j.issn.1005-0299.20150222. |
| YUAN Shuqiang,SHEN Zhengxiang,ZHOU Chunhua,LIU Fengtao,WANG Fang,YANG Hui,CHEN Jiong.Microstructure and property of 30CrMnSiNi2A in different heat treatment[J].Materials Science and Technology,2015,23(2):125-128.DOI:10.11951/j.issn.1005-0299.20150222. |
|
| 摘要: |
| 为考察热处理工艺对材料性能的影响,对不同回火温度下三种碳含量的30CrMnSiNi2A钢的性能进行实验研究,并分析其组织和断口形貌.研究结果表明:低温回火时30CrMnSiNi2A钢具有较高的强度和硬度,其内部组织为回火马氏体,断口形貌为韧窝断口；当碳含量增大,30CrMnSiNi2A钢的强度也增大；随着回火温度升高,30CrMnSiNi2A钢的强度和硬度逐渐下降,伸长率和断面收缩率却总体呈上升趋势,其组织向索氏体转变,断口形貌变为解理和沿晶断口,回火脆性与其内部形核有关. |
| 关键词: 马氏体 力学性能 断口形貌 回火脆性 |
| DOI：10.11951/j.issn.1005-0299.20150222 |
| 分类号:TG15 |
| 基金项目:宁波市重大科技攻关项目(2009B10011). |
|
| Microstructure and property of 30CrMnSiNi2A in different heat treatment |
|
YUAN Shuqiang, SHEN Zhengxiang, ZHOU Chunhua, LIU Fengtao, WANG Fang, YANG Hui, CHEN Jiong
|
|
(Ningbo Institute, China North Material Science and Engineering Technology Group Corporation, Ningbo 315013, China)
|
| Abstract: |
| To investigate the effect of heat treatment on the property of 30CrMnSiNi2A, the microstructure and fractography of 30CrMnSiNi2A with three carbon contents at different tempering temperature were analyzed. The experimental results show that the strength and rigidity of 30CrMnSiNi2A are high at low tempering temperature, of which the microstructure is tempered martensite and the fracture morphology is dimple fracture. The increase of carbon content results in increment of strength. With increasing of tempering temperature, the strength and rigidity of 30CrMnSiNi2A decrease, while the elongation and reduction of area increase in all, the microstructure transforms into sorbite structure and the fracture morphology becomes cleavage and intergranular fracture, during which the temper brittleness is related to nucleation. |
| Key words: martensite mechanical property fracture morphology temper embrittlement |
