期刊检索

  • 2024年第32卷
  • 2023年第31卷
  • 2022年第30卷
  • 2021年第29卷
  • 2020年第28卷
  • 2019年第27卷
  • 2018年第26卷
  • 2017年第25卷
  • 2016年第24卷
  • 2015年第23卷
  • 2014年第22卷
  • 2013年第21卷
  • 2012年第20卷
  • 2011年第19卷
  • 2010年第18卷
  • 第1期
  • 第2期

主管单位 中华人民共和国
工业和信息化部
主办单位 中国材料研究学会
哈尔滨工业大学
主编 苑世剑 国际刊号ISSN 1005-0299 国内刊号CN 23-1345/TB

期刊网站二维码
微信公众号二维码
引用本文:李小晴,叶辰,林正得,江南.石墨烯转移工艺对石墨烯传感器检测汞离子的影响[J].材料科学与工艺,2018,26(4):8-13.DOI:10.11951/j.issn.1005-0299.20170363.
LI Xiaoqing,YE Chen,LIN Zhengde,JIANG Nan.Effects of transfer methods on mercury ion detection by graphene sensors[J].Materials Science and Technology,2018,26(4):8-13.DOI:10.11951/j.issn.1005-0299.20170363.
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 1307次   下载 842 本文二维码信息
码上扫一扫!
分享到: 微信 更多
石墨烯转移工艺对石墨烯传感器检测汞离子的影响
李小晴1,2, 叶辰1,2, 林正得1, 江南1
(1.中国科学院 宁波材料技术与工程研究所 表面工程事业部,浙江 宁波 315201; 2.中国科学院 大学材料科学与光电技术学院,北京 100049)
摘要:
本工作采用化学气相沉积法(CVD)石墨烯制备场效应晶体管(FET)传感器,在石墨烯表面修饰DNA,用于检测汞离子.为探索转移方法对石墨烯传感器件性能的影响,制备了3种不同转移工艺的石墨烯样品,分别是PMMA转移方法中退火烧除PMMA的石墨烯、用丙酮洗去PMMA的石墨烯和Au转移的石墨烯,对石墨烯样品进行拉曼光谱、分光光度计、光学显微镜(OM)、扫描探针显微镜(SPM)的表征.通过FET转移特性曲线的输出,得到汞离子对石墨烯掺杂情况的变化,从而考察了各种石墨烯传感器对汞离子的检测性能.结果表明,Au转移的石墨烯表面清洁程度最佳,SPM图像显示其表面平坦无杂质,表面粗糙度(Ra)仅为0.45 nm.用该种石墨烯制备的传感器件对汞离子检测的检测限达10 pM,且FET的狄拉克点变化也最大,达-0.132 V.
关键词:  无机质材料  石墨烯  传感器  DNA  汞离子
DOI:10.11951/j.issn.1005-0299.20170363
分类号:TB321
文献标识码:A
基金项目:国家自然科学基金(1,9,201675165);中国科学技术部国际科技合作项目(2015DFA50760).
Effects of transfer methods on mercury ion detection by graphene sensors
LI Xiaoqing1,2,YE Chen1,2,LIN Zhengde1,JIANG Nan1
(1. Division of Surface Engineering and Remanufacturing, Ningbo Institute of Industrial Technology, Ningbo 315201, China; 2. College of Materials Science and Opto-Electronic Technology, University of Chinese Academy of Sciences, Beijing 100049, China)
Abstract:
In this work, chemical vapor deposition (CVD) graphene was decorated with DNA to fabricate field effect transistor (FET) sensors for mercury ion detection. To figure out the effects of different samples on the detection of Hg2+, this study exploited three different samples:the sample on which PMMA was burned, the sample on which PMMA was washed by acetone and the sample which was transferred by Au. The quality of the graphene was characterized by Raman spectroscopy, spectrophotometer, optical microscope as well as scanning probe microscopy. Three different devices were fabricated by corresponding samples.Through the FET transfer curves, different doping conditions of graphene were obtained, and the detetion performance of various graphene sensors was investigated. It was shown that the sample which was transferred by Au had the cleanest surface. In the corresponding device, the detection limit of Hg2+ could achieve 10 pM, and the change of Dirac point was the largest which was up to -0.132 V.
Key words:  inorganic material  graphene  sensor  DNA  Hg2+

友情链接LINKS