| 引用本文: | 王玉,袁学韬,俞宏英,孙冬柏,李辉勤.脉冲电沉积工艺对镍镀层结构与硬度的影响[J].材料科学与工艺,2010,18(1):89-95.DOI:10.11951/j.issn.1005-0299.20100120. |
| WANG Yu,YUAN Xue-tao,YU Hong-ying,SUN Dong-bai,LI Hui-qin.Influence of pulse parameters on the microstructure and microhardness of nickel electrodeposits[J].Materials Science and Technology,2010,18(1):89-95.DOI:10.11951/j.issn.1005-0299.20100120. |
|
| 摘要: |
| 为了优化脉冲电镀镍工艺,采用扫描电子显微镜、X射线衍射仪和显微硬度仪研究了脉宽、脉间、峰电流密度对镀层的晶粒尺寸、表面形貌、晶体取向和硬度的影响.结果表明,保持峰电流密度和脉间不变,镀层的晶粒尺寸随着脉宽的增加先减小后增加.当脉宽由0.1ms增至8ms,晶体取向由(111)织构向(200)织构转变.保持峰电流密度和脉宽不变,当脉间的增加,晶粒尺寸增大,但晶体的取向不变.增加峰电流密度能够显著降低镀层的晶粒尺寸.当峰电流密度由0.2A/cm2增至2.0A/cm2,晶体取向由随机态向强的(200)织构转变.镀层的硬度与镀层的晶粒尺寸有关,晶粒尺寸较大时,服从Hall-Petch关系,晶粒尺寸较小时,产生纳米效应,反Hall-Petch关系.因此,脉宽、脉间、峰电流密度均能显著影响镀层的显微硬度. |
| 关键词: 脉冲电沉积 微观结构 纳米效应 |
| DOI：10.11951/j.issn.1005-0299.20100120 |
| 分类号:TQ153.12 |
| 基金项目:国家自然科学基金资助项目(50374010);北京市教委科技发展计划重点项目(Z200410028012) |
|
| Influence of pulse parameters on the microstructure and microhardness of nickel electrodeposits |
|
WANG Yu1,2, YUAN Xue-tao3, YU Hong-ying2, SUN Dong-bai2, LI Hui-qin2
|
|
1.Chinese Academy of Cultural Heritage,Beijing 100029,China;2.School of Materials Science and Engineering,University of Science and Technology Beijing,Beijing 100083,China;3.General Research Institute for Non-ferrous Metals,Beijing 100088,China
|
| Abstract: |
| To optimize the nickel pulse plating process,the scanning electron microscope,X-ray diffraction and microhardness tester were used to determine the influence of pulse on-time,pulse off-time and peak current density on the grain size,surface morphology,crystal orientation and microhardness of the nickel electrodeposits. The study shows that at constant off-time and peak current density,the crystal size of the deposits initially decreases and then starts to increase with the increasing pulse on-time. The crystal orientation progressively changes from a (111) texture at the on-time of 0. 1 ms to a strong (200) texture at the on-time of 8 ms. The increase of pulse off-time at the constant on-time and peak current density results in a progressive increase in crystal size,while the crystal orientation remains unaffected. The increase of peak current density results in considerable refinement in crystal size of the deposits. The crystal orientation progressively changes from an almost random distribution at the lowest peak current density of 0. 2 A/cm2 to a strong (200) texture at the peak current density of 2. 0 A/cm2. The microhardness of deposits is related with grain size. When the grain size is large,the microhardness is consistent with Hall-Petch law (HPL). When the grain size is ultrafine,nanoeffect will be generated,and the microhardness is against HPL. Therefore,pulse on-time,pulse off-time and peak current density have distinct influence on microhardness of the deposits. |
| Key words: pulse plating microstructure nano effect |
