| 引用本文: | 蒋翔俊,张优云,袁淑霞.燃机端面齿微动磨损分析及数值仿真[J].哈尔滨工业大学学报,2011,43(3):75.DOI:10.11918/j.issn.0367-6234.2011.03.016 |
| JIANG Xiang-jun,ZHANG You-yun,YUAN Shu-xia.An investigation and simulation of fretting wear of curvic in a gas turbine engine[J].Journal of Harbin Institute of Technology,2011,43(3):75.DOI:10.11918/j.issn.0367-6234.2011.03.016 |
|
| 摘要: |
| 运用Archard磨损定律以及接触力学理论,研究了燃机端面齿楔形接触面在不同交变载荷力作用下接触面接触压力、接触宽度、间隙量、滑移量等接触特征参数随磨损过程的变化发展规律.结果表明,接触齿面的磨损是由于接触面间反复的相对滑动、磨损导致了接触面几何形貌以及接触压力的改变,这些因素又反过来影响磨损过程.各参数具有时间依赖性,并且之间存在不可分割的关系.将计算结果与试验结果进行比较,证明该计算模型具有有效性和合理性. |
| 关键词: 端面齿接触 磨损模型 磨损规律 磨损失效 |
| DOI：10.11918/j.issn.0367-6234.2011.03.016 |
| 分类号:TH117.1 |
| 基金项目:国家重点基础研究发展规划资助项目(2007CB707706) |
|
| An investigation and simulation of fretting wear of curvic in a gas turbine engine |
|
JIANG Xiang-jun, ZHANG You-yun, YUAN Shu-xia
|
|
Key Laboratory of Education Ministry for Modern Design and Rotor-Bearing System, Xi’an Jiaotong University,710049 Xi’an,China
|
| Abstract: |
| Archard’s wear law and the contact mechanics method are used to evaluate the evolution of contact characteristics including contact pressure,contact width,gap and slip functions under conditions of different tangential force within slip zones of curvic attachments of a gas turbine with wedge-side surface in fretting.It can be concluded that the repeated slip occurring near the edges of contact generates wear that changes the contact geometry and contact stresses.Thus,the change of contact geometry and redistribution of the contact pressure in turn influences the wear rate in the slip zones.All functions in the wear contact problem are time-dependent and inter-connected.The results,compared to the experimental ones,show that the present model is valid and reasonable. |
| Key words: curvic attachments wear model wear law wear failure |
