| 引用本文: | 付强,陈伟平,闫菁敏,尹亮,刘晓为.双片集成数字硅陀螺接口ASIC的设计与测试[J].哈尔滨工业大学学报,2017,49(10):90.DOI:10.11918/j.issn.0367-6234.201607103 |
| FU Qiang,CHEN Weiping,YAN Jingmin,YIN Liang,LIU Xiaowei.Design and test of the interface of the dual-chip integrated digital silicon gyroscope ASIC[J].Journal of Harbin Institute of Technology,2017,49(10):90.DOI:10.11918/j.issn.0367-6234.201607103 |
|
| 本文已被：浏览 2041次 下载 950次 |
码上扫一扫！ |
|
|
| 双片集成数字硅陀螺接口ASIC的设计与测试 |
|
付强1,2,陈伟平1,2,闫菁敏1,尹亮1,2,刘晓为1,2
|
|
(1. 哈尔滨工业大学 MEMS中心,哈尔滨150001; 2.微系统与微结构教育部重点实验室 (哈尔滨工业大学),哈尔滨150001)
|
|
| 摘要: |
| 为实现MEMS陀螺高精度、数字化和小型化，适应惯性导航和测量等领域的应用要求，采用双片集成方式，基于0.5 um的N阱CMOS工艺，设计并实现了一款实用化的MEMS陀螺接口电路.设计了基于高频载波的闭环自激驱动电路和低噪声差分敏感检测模拟前级电路，高频信号将敏感信号调制到高频后与闪烁噪声相加，经过开关相敏解调以及低通滤波后得到低噪声模拟角速度输出，并由集成的高分辨率四阶单环一位sigma delta ADC将模拟信号转化成为数字信号，实现数字化输出的硅陀螺接口电路.测试结果表明：sigma delta调制器的动态范围达到130 dB，陀螺整机量程为±200 °/s，带宽为60 Hz，刻度因子为46.45 LSB/((°)·s-1)；线性度为342×10-6，输出噪声为0.004(°)·s-1/Hz1/2，零偏稳定性为3.4 °/h.通过电路集成实现了小型化、低成本和角速度数字化精确输出, 测试结果与其他相关研究对比表明该结构可以得到很好的性能.
|
| 关键词: 数字化系统 硅陀螺 sigma delta ADC ASIC 低噪声 |
| DOI：10.11918/j.issn.0367-6234.201607103 |
| 分类号:TN492 |
| 文献标识码:A |
| 基金项目:上海航天科技创新基金(SAST2015052) |
|
| Design and test of the interface of the dual-chip integrated digital silicon gyroscope ASIC |
|
FU Qiang1,2,CHEN Weiping1,2,YAN Jingmin1,YIN Liang1,2,LIU Xiaowei1,2
|
|
(1.MEMS Center, Harbin Institute of Technology, Harbin 150001, China; 2.Key Laboratory of Micro-systems and Micro-structures Manufacturing of Ministry of Education (Harbin Institute of Technology), Harbin 150001, China)
|
| Abstract: |
| In order to realize the high precision, digital and miniaturization of MEMS gyroscope, which is the application requirements of the field of inertial navigation and measurement, this paper designs and implements a practical MEMS gyroscope interface circuit which adopts the process of dual-chip integration, integrated based on N-well CMOS process of 0.5 μm. The paper introduces the design of analog front-end circuit which contains closed-loop self-exciting driving structure based on high-frequency carrier and low noise differential sensitive detection circuit. The high frequency signal modulates the sensitive signal to the high frequency and adds the flicker noise. Through the phase sensitive demodulation and low-pass filtering, the low noise analog angular speed output is obtained. The circuit converts analog signal into digital signal by an integrated high-resolution sigma delta four-order single ring one bit ADC, achieving an interface circuit of silicon gyroscope with digital output. Test results show that the dynamic range of the modulator which bandwidth and scale factor are 60 Hz and 46.45 LSB/(°)·s-1, respectively, is up to 130 dB, and the measuring range of gyroscope is ±200 °/s. The linearity of the modulator with the noise of 0.004 (°)·s-1/Hz1/2 is 340×10-6, and the stability of the zero bias is 3.4 °/h. It enables miniaturization, low cost and precise digital output of angular speed through integrated circuit. Comparison of the test results with other related research also confirms that the structure can achieve good performance.
|
| Key words: digitalized system silicon gyroscope sigma delta ADC ASIC low noise |
