| 引用本文: | 曾楠,柴希娟,胡玲华,张学良,吴春华.ZnO复合石墨相氮化碳纳米片的制备及其光催化性能研究[J].材料科学与工艺,2023,31(4):41-50.DOI:10.11951/j.issn.1005-0299.20220372. |
| ZENG Nan,CHAI Xijuan,HU Linghua,ZHANG Xueliang,WU Chunhua.Preparation and photocatalytic properties of ZnO composite graphitic carbon nitride nanosheets[J].Materials Science and Technology,2023,31(4):41-50.DOI:10.11951/j.issn.1005-0299.20220372. |
|
| |
|
|
| 本文已被：浏览 641次 下载 868次 |
码上扫一扫！ |
|
|
| ZnO复合石墨相氮化碳纳米片的制备及其光催化性能研究 |
|
曾楠1,柴希娟1,2,胡玲华1,张学良1,吴春华1,2
|
|
(1.西南地区林业生物质资源高效利用国家林业和草原局重点实验室(西南林业大学),昆明650224; 2. 西南林业大学 林业生物质资源高效利用技术国家地方联合工程研究中心,昆明 650224)
|
|
| 摘要: |
| 为了提高石墨相氮化碳光催化性能,本文以尿素、硫脲、醋酸锌为前驱体,通过氧化热剥离与共混煅烧法分别制备g-C3N4纳米片和ZnO/g-C3N4异质结复合材料,并采用TEM、FTIR、XRD、UV-Vis DRS、BET等表征手段对制备的催化剂进行结构表征。以罗丹明、大肠杆菌为探针,考察了催化剂的光催化降解性能和抑菌活性。结果表明:以尿素和硫脲为前驱体,经过氧化热剥离处理后能得到的g-C3N4 2D纳米片,其比表面积更大、光催化性能更加优异,且其对罗丹明的降解率较未剥离的g-C3N4提高了21.2％。在40 min氙灯照射下,纯g-C3N4并未表现出良好的抑菌性能,而通过ZnO复合制备的ZnO/g-C3N4异质结复合材料,在光催化降解率和抑菌活性方面均有很大提高,其中复合20％ZnO制得的ZnO异质结复合材料表现出最佳的光催化性能,在60 min氙灯光照下,对质量浓度为10 mg/L的罗丹明溶液降解率达到了91.2％。20％ZnO/g-C3N4对大肠杆菌表现出优异的抑菌活性,经过40 min氙灯照射后,其对浓度为106 cfu/mL菌悬液抗菌率达到100％。石墨相氮化碳可以通过氧化热剥离增大比表面积,然后再与金属氧化物ZnO复合,通过减小禁带宽度,扩大可见光的利用范围,从而达到提高光催化性能的目的。 |
| 关键词: g-C3N4纳米片 ZnO/g-C3N4 光催化降解 大肠杆菌 抗菌活性 |
| DOI：10.11951/j.issn.1005-0299.20220372 |
| 分类号:O643.36 |
| 文献标识码:A |
| 基金项目:国家自然科学基金资助项目(31960297,32160414). |
|
| Preparation and photocatalytic properties of ZnO composite graphitic carbon nitride nanosheets |
|
ZENG Nan1,CHAI Xijuan1,2, HU Linghua1, ZHANG Xueliang1, WU Chunhua1,2
|
|
(1. Key Laboratory of the State Forestry and Grassland Administration on Highly-Efficient Utilization of Forestry Biomass Resources in Southwest China (Southwest Forestry University), Kunming 650224,China; 2. Southwest Forestry University, National and Local Joint Engineering Research Center for Efficient Utilization of Forest Biomass Resources, Kunming 650224,China)
|
| Abstract: |
| In order to improve the photocatalytic performance of graphite phase carbon nitride, g-C3N4 nano-sheet and ZnO/g-C3N4 heterojunction composite were prepared using urea, thiourea and zinc acetate as precursors by oxidative thermal stripping and blending calcination, respectively. The structure of the prepared catalyst was characterized by TEM, FTIR, XRD, UV-Vis DRS, BET and other characterization methods. Using Rhodamine and Escherichia coli as probes, the photocatalytic degradation performance and antibacterial activity of the catalyst were investigated. The results showed that the specific surface area of g-C3N4 2D nano-sheets obtained from urea and thiourea as precursors after oxidative thermal stripping treatment was larger, and their photocatalytic performance was better, and their degradation rate of rhodamine was 21.2% higher than that of g-C3N4 without stripping. Under 40 min xenon lamp irradiation, pure g-C3N4 did not show good bacteriostatic performance, while ZnO/g-C3N4 heterojunction composite prepared by ZnO composite showed great improvement in photocatalytic degradation rate and bacteriostatic activity, among which ZnO heterojunction composite prepared by 20%ZnO composite showed the best photocatalytic performance, and under 60 min xenon lamp illumination, the degradation rate of rhodamine solution with a mass concentration of 10 mg/L reached 91.2%. 20%ZnO/g-C3N4 showed excellent antibacterial activity against Escherichia coli. After 40 minutes of xenon lamp irradiation, its antibacterial rate against 106 cfu/mL bacterial suspension reached 100%. Graphite phase carbon nitride can increase the specific surface area by oxidative thermal stripping, and then compound with metal oxide ZnO. By reducing the band gap, the utilization range of visible light can be expanded, in order to improve the photocatalytic performance. |
| Key words: g-C3N4 nanosheet ZnO/g-C3N4 photocatalytic degradation Escherichia coli antibacterial activity |
|
|
|
|
