期刊检索

  • 2024年第56卷
  • 2023年第55卷
  • 2022年第54卷
  • 2021年第53卷
  • 2020年第52卷
  • 2019年第51卷
  • 2018年第50卷
  • 2017年第49卷
  • 2016年第48卷
  • 2015年第47卷
  • 2014年第46卷
  • 2013年第45卷
  • 2012年第44卷
  • 2011年第43卷
  • 2010年第42卷
  • 第1期
  • 第2期

主管单位 中华人民共和国
工业和信息化部
主办单位 哈尔滨工业大学 主编 李隆球 国际刊号ISSN 0367-6234 国内刊号CN 23-1235/T

期刊网站二维码
微信公众号二维码
引用本文:余琼,许雪静,尤高帅.带肋钢筋与灌浆料黏结性能试验[J].哈尔滨工业大学学报,2017,49(12):91.DOI:10.11918/j.issn.0367-6234.201701088
YU Qiong,XU Xuejing,YOU Gaoshuai.Experimental study on bond behavior for ribbed steel bars and grout[J].Journal of Harbin Institute of Technology,2017,49(12):91.DOI:10.11918/j.issn.0367-6234.201701088
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
过刊浏览    高级检索
本文已被:浏览 2804次   下载 1318 本文二维码信息
码上扫一扫!
分享到: 微信 更多
带肋钢筋与灌浆料黏结性能试验
余琼,许雪静,尤高帅
(同济大学 结构工程与防灾研究所,上海 200092)
摘要:
为灌浆料在预制装配式结构及加固改造领域提供理论依据,进行了27个带肋钢筋-灌浆料拉拔试验,研究了试件的破坏模式和黏结强度随变量的变化规律,分析了灌浆料开裂、压碎过程及与过程相对应的典型黏结-滑移曲线各阶段.基于试验数据,拟合了灌浆料黏结锚固强度公式、黏结强度对应的滑移值公式和黏结应力-滑移关系式,提出了钢筋在灌浆料中的锚固长度经验值.结果表明:随着保护层厚度增大,试件平均黏结强度不断增大,相比于混凝土,保护层厚度增大相同幅度,灌浆料黏结强度增长慢;随着钢筋直径增大,平均黏结强度减小;随着钢筋锚固长度增加,试件平均黏结强度降低,相比于自密实混凝土,锚固长度增加相同幅度,灌浆料黏结强度增长快;强度等级相同时,灌浆料黏结强度高于普通混凝土;钢筋与灌浆料间黏结性能和钢筋与混凝土间黏结性能有差异.
关键词:  灌浆料  带肋钢筋  典型黏结-滑移曲线  劈裂破坏  滑移面  锚固长度
DOI:10.11918/j.issn.0367-6234.201701088
分类号:TU375
文献标识码:A
基金项目:
Experimental study on bond behavior for ribbed steel bars and grout
YU Qiong,XU Xuejing,YOU Gaoshuai
(Research Institute of Structural Engineering and Disaster Reduction, Tongji University, Shanghai 200092, China)
Abstract:
To provide theoretical data for the grout used in prefabricated structures and reinforcement reconstruction field. Pull-out tests were conducted on 27 specimens having grout with ribbed reinforced bars, and the failure mode and the variation of bond strength were studied. According to a typical bond-slip curve, the cracking, crushing and shearing process were analyzed. Based on the experimental data, the bond strength formula, the slip formula and the bond-slip formula were fitted. The empirical value of anchorage length of reinforcement in grout was presented. The result shows that the average bond strength increases with the increase of the cover thickness. While thickening the cover thickness, the increasing rate of bond strength is lower than that of concrete. In addition, increasing the bar diameter, the average bond strength decreases. Further-more, with the increase of the anchorage length, average bond strength decreases. The increase of anchorage length results in higher increment rate of the bond strength of grout compared to the self-compacting concrete. With the same compressive strength grade, the bond strength of grout is higher than that of ordinary concrete. In conclusion, the bond-slip behavior between ribbed steel bar and grout is different from that of concrete.
Key words:  grout  ribbed steel bar  typical bond-slip curve  splitting failure  slip surface  anchorage length

友情链接LINKS